Vista Ademco -10SE Instrukcja Naprawy Pobierz pdf (Strona 73)

Learn S/N ?

O= No, l= Yes O

TRANSMIT NOW

~ical summarydisplay

7. Ress “1”(Yes).

Activate the transmitter by pressing and

releasing its button, opening and closing a

contact, etc. A “beep” will be heard. After

approximately 8 seconds, activate the

transmitter again – 2 “beeps” will occur,

indicating that the unit has been accepted

into the system.

Now.

A singlelong beep indicatesthat that

serial number has been previously accepted

for the system.

If necessary, refer temporarily

to “58oo

Series Transmitters Table* in the

WIRELESS EXPANSION section for the

specificmethod used to activateeach of the

availabletransmitters.

Ress * to continue.

summary

of the zone progrsmmin

gwillbe

displayed, with a flashing cursor over the

learnedloopnumber %“.

AcceptedInput(Luop)I$Jumber

Press * to continue to the next zone (if

required*). A prompt for an entry for the

next zone in numerical order will be

displayed.

* If the transmitter has more than one

button, or has contact terminals and a

reed switch (such as the 5816), repeat

the previous procedure for each of the

remaining buttons or contacts (each

button, etc., must be assigned to a

dii%erentzone).

Deleting a Sarial Number

1. With at least one 2-line Alpha keypad (5137AD or 6139) connectedto the

system, power up the system temporarily. If the AC transformer was

previously connectedto the control panel, plug in the transformer (to

120VAC outlet)to powerup the system.

2. Enter the progr

amming mode by keying the following on the Alpha

keypad

Installer code (411 2)+ 8+ O+ 0.

m “’”playd”

3. Ress *83. A prompt to enter zone number

-73-

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 119 120

Komentarze do niniejszej Instrukcji

Brak uwag

Vista Ademco -10SE Instrukcja Naprawy Strona 73

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Vista Ademco -10SE