Vista Ademco -10SE Instrukcja Naprawy Pobierz pdf (Strona 26)

Enter the partiti~n to which this zone is

assigned, “1“ or “2”. The factory default is

partition 1. Press [*I to continue.

ml for~~d[~][~]forct. R~~er~o&ct&m17

The report codeconsistsof 2 hexadecimaldigits,

eachin turn consistingof 2 numerical digits.For

example, for a report codeof 3C , enter

[01[31

SYSTEM COMMUNICATION

for complete

information on report codes,if necessary.

Enter the desiredreport codeand then press [*I

to continue.

-l ~~%~$~$5~0-=10m~e~,u~=

Enter the desired response time for the zone.

Press [*I ~ocontinue.

T@ical summarydisplay

-l ~on,ue

A summary dispIay will appear, showing the

data for the zonethat wasjust programmed.

If It IS programmed satisfactorily, press [*I to

UIEEEIl

The next request is to enter Alpha descriptors

for the zones. The entry may be donenow (enter

1) or may be done at a later time using *82

interactive mode (enter O).We recommend that

the entry of Alpha descriptors’bedoneusing %2

mode.

See

Section 15. ALPHA DESCRIPTION

PROGRAMMING for specifi procedure

a.one.s.~ca.dpre.ously

If “O* (no) was entered above, the system will

return to the Enter Zone Number prompt.

Proceed vmth the programming for the next

Whe~ you have programmed all the hard-wired

zones satisfactorily, exit *56 interactive mode at

the Enter Zn Num. prompt by pressins [01[01*

Then exit the programming modeby keying -.

Proceedto the check-outprocedurethat follows.

-26-

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 119 120

Brak uwag

Vista Ademco -10SE Instrukcja Naprawy Strona 26