Vista Ademco -10SE Instrukcja Naprawy Pobierz pdf (Strona 30)

II

10 ReportCode

1st 03 2nd 12 3C

II

Typicalsummary

display

The report codeco~ists of 2 hexadecimaldigits,

eachin hum consistingof2 numerical digits. For

example, for a report codeof “3C”, enter [0][3]

for “3” and [1][2] for “C”. Refer to

SYSTEM

COMMUNICATION

section for complete

information on report codes,if necessary.

Enter the report code and then press [*I to

continue.

A summary display will appear, showing the

data for the zone that was just programmed.

Note that AW indicatesan auxiliary wired (zone

expansionmodule) zone.

If it is programmed satisfactorily, press [*I to

display the next prompt.

For all zone lypes, the next request is to enter

Alpha descriptorsfor the zones. The entry may

be done now (enter 1) or maybe done at a later

time using *82 interactive mode (enter O). We

recommendthat the entry of Alpha descriptors

be donelater using *82 interactivemenu mode.

See Section 15.

ALPHA DESCRIPTION

PROGRAMMING

for speciticprocedure.

‘lpretio.slY

If “O” (No) was entered above, the system will

display a prompt for entry of the next wired

expansion zone number. Proceed with the

programming for the next zone, as indicated

When you have programmed all the wired

expansion zones satisfactorily, exit *56

interactivemode at the Enter Zn Nu.m. prompt

by pressing[0] [0]*.

Themexitthe programming

g mode by keying ~.

Proceedto the check-outprocedurethat follows.

-30-

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 119 120

Komentarze do niniejszej Instrukcji

Brak uwag