Vista Ademco -10SE Instrukcja Naprawy Pobierz pdf (Strona 14)

Mounting Control and RF Receiver Ckuit Boarda Togetbr, b the Cebmet

Hang two short (black) mounting clips (provided with receiver) on the

raised cabinettabs,as shownin Detail B in Figure 3.

Insert the top of the receiver board (removed from its own case as de-

scribed in its instructions) into the slots at the top of the cabinet, as

shownin Detail A in Figure 3. Make sure that the board rests on the cor-

rectrow of tabs,as shown.

Swing the baseof the board into the mounting clips and secureit to the

cabinetwith the accompanyingscrews(seeDetail Bin Fig. 3).

Insert the top of the control’sboard into the slot in the clipsand position

two long (red) clipsat the lower edgeof the board (seeDetail C).

Swing this boardinto placeand secureit with two additional screws.

Insert grounding lugs (supplied with the receiver)through the top of the

cabinetinto the left-hand terminals of the antenna blocks(at the upper

edgeof the receiverboard) and securethem to the cabinettop with the

screwsprovided,as shownin Detail D.

Insert the receiver’santennas through the top of the cabinet,into the

blocks’

right-hand terminals, and tighten the screws.

Refer to the WIRELESS ZONE EXPANSION sectionfor setup and wiring

of the receiver.

i4vLEs mm AN7HNWS

AND GROIJNLWJC LUGS

SOAm SUPPOSTING SLo’rs

RESEIESEII

Uncul-f

MAW

SoARo

DC-rut A

sJcnEmEw OF

BoARo wPPORllNG SLOB

SHORT(sIA@ MOUNTINGCLIPS >

COwROl.

w-y

LONG(FEO)MOUNTINGCLIPS

ILu

Oc?m m

S40E WEWOF

- MOUNTING CLIPS

SCREW

OrrAIL c

~ ANTENNA

SIDEVIEWof

LONGMOusnw CLIPS

GROUNOING LUG “

h— :’::

‘f=

Figure 3. Mounting 7be PC Board And RF Receiver Together In lb Cabinet

-14-

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 119 120

Komentarze do niniejszej Instrukcji

Brak uwag

Vista Ademco -10SE Instrukcja Naprawy Strona 14

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Vista Ademco -10SE